Endress+Hauser Levelflex FMP55 Operating Instructions Manual page 85

Levelflex FMP55 FOUNDATION Fieldbus
Endress+Hauser
12.8.1 Event groups
The diagnostic events are divided into 16 groups according to the source and the
weighting. A default event category is assigned to each group at the factory. Here, one
bit of the assignment parameters belongs to every event group.
Event weighting Default event category
Highest weighting Failure (F)
1) This event can be removed from the group and treated separately; see the "Configurable area" section.
Event weighting Default event category
High weighting Function check (C)
Event weighting Default event category
Low weighting Out of specification (S)
Commissioning (block-oriented operation)
Event source Bit Events in this group
Sensor 31 • F003: Broken probe detected
• F046: Buildup detected
• F083: Memory content
• F104: HF cable
• F105: HF cable
• F106: Sensor
Electronics 30 • F242: Software incompatible
• F252: Modules incompatible
• F261: Electronic modules
• F262: Module connection
• F270: Main electronic failure
• F271: Main electronic failure
• F272: Main electronic failure
• F273: Main electronic failure
• F275: I/O module failure
• F276: I/O module failure
• F282: Data storage
• F283: Memory content
• F311: Memory content
Configuration 29 • F410: Data transfer
• F411: Upload/download
• F435: Linearization
• F437: Configuration incompatible
Process 28 • F803: Loop current 1
• F825: Operating temperature
• F936: EMC interference
• F941: Echo lost
• F970: Linearization
Event source Bit Events in this group
Sensor 27 Not used in Levelflex
Electronics 26 Not used in Levelflex
Configuration 25 • C411: Upload/download
• C431: Trim
• C484: Failure mode simulation
• C485: Simulation measured value
• C491: Simulation current output
• C585: Simulation distance
Process 24 Not used in Levelflex
Event source Bit Events in this group
Sensor 23 Not used in Levelflex
Electronics 22 Not used in Levelflex
1)
85