Table of Contents
Advertisement
SL-B9D-FGR
Onboard Serial
Port 1 / Port 2
UART Mode Select The serial port on your system may offer a vari-
x RxD , TxD Active The option controls the speed between receiving and
x IR Transmission
x UR2 Duplex Mode This options controls the operating mode between
x Use IR Pins When UART Mode is selected in IrDA or ASKIR
Onboard Parallel Port This item allows you to determine onboard parallel
Parallel Port Mode Select an operating mode for the on-board parallel
x EPP Mode Select Select a EPP Mode for EPP or ECP+EPP mode in
x ECP mode Use DMA Select a DMA channel for the port for ECP or
GigaLAN To enable/disable the onboard GigaLAN (10/100/
Select an address and corresponding interrupt
for the first/second serial port.
Choices: Disabled; Auto;
ety of infrared port modes. Click here for a de-
scription of various modes.
The choices: Normal; IrDA; ASKIR
transmitting of IrDA or ASKIR when using.
Choices: Hi,Hi; Hi,Lo; Lo,Hi; Lo,Lo
When UART Mode is selected in IrDA or ASKIR
Delay
mode, it allows you to enable / disable IR Transmis-
sion Delay.
receiving and transmitting of IrDA or ASKIR or SCR.
Choices: Half (asynchronous); Full (synchronous)
mode, this item letss you select IR Pins signal.
Choices: IR-Rx2Tx2; RxD2, TxD2
port controller I/O address setting.
Choices: 378H/IRQ7; 278H/IRQ5; 3BC/
(printer) port.
Choices: SPP; EPP; ECP; ECP+EPP
the Parallel Port Mode.
Choices: EPP1.7; EPP1.9
ECP+EPP mode of the Parallel Port Mode.
Choices: 1; 3
1000) interface.
1394 To enable/disable the onboard 1394 interface.
3F8/IRQ4; 2F8/IRQ3;
3E8/IRQ4; 2E8/IRQ3
IRQ7; Disabled
70
Chapter 4 BIOS Setup
Advertisement
Table of Contents
