Using Via Raid Bios Setup To Change Array Mode - SOLTEK SL-B9D-FGR Manual

SL-B9D-FGR

5-5 Using VIA RAID BIOS Setup to change Array mode

(5-5-1) If you wants to change the RAID mode, say, from RAID 0 to
RAID 1, you must return to the Initial RAID BIOS Setup screen. Then,
press the "Arrow" key to mark the "Delete Array" bar and press <Enter>.
Create Array
Delete Array
Create/Delete Spare
Select Boot Array
Serial Number View
Channel
Channel0 Master
Channel0 Slave
Channel1 Master
Channel1 Slave
(5-5-2) Instantly, the Bootable Hard Disk(s) is marked up for deletion.
Press <Enter> key on this screen to delete the set-up array.
VIA Tech. VT8237 SATA RAID BIOS Ver 2.10
Create Array
Delete Array
Create/Delete Spare
Select Boot Array
Serial Number View
Channel
[ ] Channel0 Master
Channel0 Slave
[ ]Channel1 Master
Channel1 Slave
VIA Tech. VT8237 SATA RAID BIOS Ver 2.10
Drive Name
ST380023AS
No Drive
ST380023AS
No Drive
Drive Name
ST380023AS
No Drive
ST380023AS
No Drive
Chapter 5 VIA VT8237 RAID Setup
Delete a RAID array contain the
hard disks attatched to VIA RAID
controller
F1 : View Array/disk Status
: Move to next item
Enter : Confirm the selection
ESC : Exit
Array Name Mode
ARRAY 0 ATA 133
ARRAY 0
ATA 133
Delete a RAID array contain the
hard disks attatched to VIA RAID
controller
F1 : View Array/disk Status
: Move to next item
Enter : Confirm the selection
ESC : Exit
Array Name Mode
ARRAY 0 ATA 133
ARRAY 0
ATA 133
89
Size(GB) Status
74.53 Boot
74.53 Boot
Size(GB) Status
74.53 Boot
74.53 Boot