Atx Power Supply Installation - SOLTEK SL-B9D-FGR Manual

SL-B9D-FGR

2-7 ATX Power Supply Installation

Main Power
Connector
+12V
5SB
PWR OK
GND
+5V
GND
+5V
GND
+3.3V
+3.3V
Pin1
ATX V2.03 Power Supply is strongly recommended for mainboard run-
ning with this mainboard.
To set up Power Supply on this mainboard:
1. Connect the on-board Main Power Connector (20-pin) to the Main
Power Connector (20-pin) of an ATX Power Supply which can be of
the latest version 2.03 model, and then connect the square-shaped
+12V Power Connector on board to the square-shaped +12V Power
Connector of the Power Supply.
Warning: Both the Main Power Connector and the +12V Power
Connector should be connected to Power Supply; otherwise, the
system may either not start or be damaged.
2. This ATX Power Supply should be able to provide at least 720mA/
+5V standby power for Wake On Lan function.
DIMM1
DIMM2
+5V
+5V
-5V
GND
GND
GND
PS ON#
GND
-12V
+3.3V
Pin11
Chapter 2 Hardware Setup
Dual-Channel DDR 400/333/266/200 MHz
+12V Power Connector
GND
1
3
+12V
23
GND
2
4
+12V