SOLTEK SL-B9D-FGR Manual page 62

SL-B9D-FGR
AGP & P2P Bridge Control:
To press< Enter > on AGP & P2P Bridge will reveal the following item.
AGP Aperture Size Options: 32; 64; 128; 256M; 512M; 1G. Memory
AGP 3.0 mode To show the AGP onboard mode.
AGP Driving Control To automatically/manually set AGP Driving Control.
x AGP Driving Value To input AGP Driving Value if you have set "Manual"
AGP Fast Write This item will enable the AGP mode into fast write
AGP Master 1 WS
AGP Master 1 WS
AGP3.0 Calibration To enable / disable of support
DBI Output for AGP
DRAM Configuration:
To press< Enter > on DRAM Configuration will reveal the following item(s).
Current FSB Frequency BIOS shows the actual Front Side Bus frequency.
Current DRAM Frequency BIOS shows the actual DRAM frequency.
Max Memclock (Mhz) To manually set the memory clock if you have set
1T/2T Memory Timing To manually/ automatically set the DDR Timing.
CAS# LATENCY(Tcl) Automatically set CAS# latency.
RAS# to CAS# delay
mapped and graphics data structures can reside in
a Graphics Aperture. This area is like a linear buffer.
BIOS will automatically report the starting address
of this buffer to the O.S.
in above item.
Choices: 00~FF in 01 stepping
mode. If your graphics card does not support this
function, please do not enable this function.
To enable / disable the support of AGP Master 1
Write Waite State Write.
To enable / disable the support of AGP Master 1
Read Waite State Read.
To auto-detect / disable the DBI Output for AGP
Trans transfer.
"by manual" in above option.
Choice: Auto; 100; 133; 166; 200
Choose the RAS to CAS delay time.
Choices: Auto; 2; 3; 4; 5; 6; 7
(Trcd)
65
Chapter 4 BIOS Setup