Table of Contents
Advertisement
iSitePower-M V100R002C00
User Manual (MAP05A1, MAB05B1)
Table 3-2 Terminals on the panel
Pin
1
2
3
4
5
6
7
9
10
8
Note [1]: For a genset that starts when the dry contact is open, connect the
signal cable to ports NC and COM. For a genset that starts when the dry contact
is closed, connect the signal cable to ports NO and COM.
WiFi Switch
The power module has a built-in WiFi module. You can press the WiFi switch to
enable or disable WiFi and reset the passwords of WiFi and the monitoring unit.
●
●
●
Password reset will result in system restart, which may interrupt the power supply
to loads. Therefore, you are advised not to reset the passwords when power is
supplying to loads.
Issue 03 (2022-10-28)
Signal
RS485A
RS485B
NC
COM
NO
DIN1+
DIN1-
DIN2+
DIN2-
GND
Enable/Disable WiFi: Hold down the WiFi switch for at least 10s to enable or
disable WiFi. The WiFi function is disabled by default.
WiFi password and monitoring unit password reset: Press the WiFi switch for
three times within 10s and each time lasts for 1s. Wait for more than 1s each
time before pressing the switch again. Then the WiFi module is restarted, and
the WiFi password and monitoring unit password are reset successfully.
The last six digits of the product WiFi name are the same as the last six digits
of the product SN. The default password is Changeme.
NO TICE
Copyright © Huawei Digital Power Technologies Co., Ltd.
Description
RS485 signal
Dry contact
output NC
terminal
Dry contact
output common
terminal
Dry contact
output NO
terminal
Dry contact input
DIN 1
Dry contact input
DIN 2
-
3 Components
Function
Reserved ports
● Connect to a
genset and
control genset
startup and
shutdown
[1]
signals
.
● Connect to an
EPO switch to
remotely shut
down the device.
In the grid + genset
scenario, the DIN dry
contacts are used to
detect grid signals.
-
26
Advertisement
Table of Contents
