Tubing Adapter
Fittings (continued)
Quick Disconnect
Thermo Scientific
6. Install the hex nut on the adapter and hand-tighten.
Caution Do not tighten tube fitting hex nut with a wrench. Tight
connections can be easily made by hand.
These fittings are found on the water inlet. See Figure 5-4.
Fittings
Note The quick disconnect fittings contain valves and if not properly
inserted, water will not flow.
To insert the inlet tubing:
1. Press on the metal thumbpad on the unit to ensure the fitting is open.
2. Install the coupling insert into the coupling body until a click is heard.
Gently pull on the tubing to verify it is secure.
3. To remove, press the metal thumbpad to release and pull coupling
insert out.
Coupling Body
Figure 5-4. Quick Disconnect
s
Push down on thumbpad
to release coupling insert
s
Coupling Insert
EASYpure RoDi
Section 5
Installation
5-3