Section 5
Installation
Component
Installation
Figure 5-5. UV Lamp Installation
UV Lamp Installation
5-4
EASYpure RoDi
Before the EASYpure RODI is mounted, install the UV lamp as follows:
1. Remove the Ventgard cap and remove the screws securing the
EASYpure RODI top cover.
2. Remove the top cover by lifting straight up.
3. Locate the UV oxidation chamber and pull the top black plastic cover
off. Do not pull on the cable.
4. Remove the lamp from its container. DO NOT TOUCH THE
GLASS PORTION OF THE LAMP. It is recommended that lint free
gloves be worn when handling the lamp. The glass portion must be free
of fingerprints, perspiration, etc. Even a light coating of perspiration
will reduce the effectiveness of the lamp.
5. Clean the lamp with isopropyl alcohol and a lint free cloth.
Caution Do not rotate the metal cover as this will loosen the water tight
seal and thus damage the UV lamp.
BLACK PLASTIC COVER
RECEPTACLE
U.V. LAMP
U.V. CHAMBER
Thermo Scientific