Table of Contents
Advertisement
0.2 Micron Final Filter
Replacement
Ventgard Cap
Replacement
Fuse Replacement
Thermo Scientific
Replace the 0.2 micron final filter whenever any of the following
conditions occur: product water flow rate is reduced, bacteria break
through, when cartridges are replaced, or when system is cleaned. The 0.2
micron final filter is shipped assembled with a bell. To replace the 0.2
micron final filter assembly:
1. Remove the old 0.2 micron final filter assembly by turning it to the
left to unscrew it from the draw-off valve.
2. Remove the new 0.2 micron final filter assembly from its bag and
insert it into the draw-off valve. Gently tighten, turning the filter to
the right.
Note It is suggested that Teflon tape be applied to the threads of the 0.2
micron final filter to ensure a tight seal.
3. Open the draw-off valve and flush at least 3 liters (1/2 reservoir
volume) of water through the 0.2 micron final filter.
The purifying media and filter in the Ventgard filter element have a
limited capacity. Therefore, the Ventgard cap should be replaced every 120
days. The Ventgard cap is shipped as a complete unit; replacement involves
simply removing the new Ventgard cap from its plastic storage bag and
placing it on the reservoir. A Ventgard cap can be stored in a cool, dry
place for two years, provided its plastic storage bag has not been opened.
1. Turn off the EASYpure RODI and disconnect it from the power
supply. Remove the power cord.
2. Pull out the fuse drawer located in the power entry module.
3. Remove old fuses and replace with fuses of the same type and rating.
See Replacement Parts section.
4. Replace fuse drawer.
Warning Replace fuses with those of the same type and rating.
5. Reattach the power cord and reconnect the unit to the power supply.
6. Operate normally.
Maintenance and Servicing
s
EASYpure RoDi
Section 9
s
9-13
Advertisement
Table of Contents
