Table of Contents
Advertisement
Thermo Scientific
Controls and Normal
Section 6
Operation
The power switch on the EASYpure RODI is located on the back right
side of the unit directly above the power cord receptacle.
The EASYpure RODI control panel incorporates three switches, a digital
display and three LEDs.
FLUSH
Figure 6-1. Control Panel
Note When the unit is first put in the Run Mode, the display will show
10.0 for a few seconds. This is an arbitrary number indicating the unit is
running. Any number that appears after 10.0 indicates DI water purity.
Note On initial power-up, the display will run the following sequence:
- Model type is scrolled: "ro-di"
- The display's LEDs will light up,
- Followed by the unit software revision,
- Finally, "IdL" will be displayed.
Warning Do not operate unit with door open. Inlet pressure may force
RO prefilter out of position.
Warning Do not use in the presence of flammable or combustible
materials; fire or explosion may result. This device contains components
which may ignite such materials.
RO System Operating
Low RO Purity
Replace RO Prefilter
START/STOP
s
s
s
EASYpure RoDi
6-1
Advertisement
Table of Contents
