Sun Microsystems Sun Fire V440 Diagnostics And Troubleshooting Manual page 43

prtconf Command Output
CODE EXAMPLE 2-7
System Configuration:
Memory size: 16384 Megabytes
System Peripherals (Software Nodes):
SUNW,Sun-Fire-V440
packages (driver not attached)
SUNW,builtin-drivers (driver not attached)
deblocker (driver not attached)
disk-label (driver not attached)
[...]
pci, instance #1
pci, instance #2
isa, instance #0
flashprom (driver not attached)
rtc (driver not attached)
i2c, instance #0
The prtconf command's -p option produces output similar to the OpenBoot
show-devs command (see "show-devs Command" on page 23). This output lists
only those devices compiled by the system firmware.
prtdiag Command
The prtdiag command displays a table of diagnostic information that summarizes
the status of system components.
The display format used by the prtdiag command can vary depending on what
version of the Solaris operating environment is running on your system. Following
are several excerpts of the output produced by prtdiag on a "healthy" Sun Fire
V440 server running Solaris 8 software.
Sun Microsystems
i2c-bridge (driver not attached)
i2c-bridge (driver not attached)
temperature, instance #3 (driver not attached)
Chapter 2 Diagnostics and the Boot Process
sun4u
25