Sun Microsystems Sun Fire V440 Diagnostics And Troubleshooting Manual page 198

What to Do
1. Connect an Ethernet cable to the network management port.
2. Log in to the ALOM system controller through the serial management port.
For more information about connecting to the serial management port, see "How to
Use the Serial Management Port" on page 178.
3. Type one of the following commands:
If your network uses static IP addresses, type:
sc> setsc if_network true
sc> setsc netsc_ipaddr ip-address
sc> setsc netsc_ipnetmask ip-address
sc> setsc netsc_ipgateway ip-address
You can also use the setupsc command.
If your network uses Dynamic Host Configuration Protocol (DHCP), type:
sc> setsc netsc_dhcp
4. To verify the network settings, type:
sc> shownetwork
5. Log out of the ALOM system controller session.
What Next
To connect to the system console through the network management port, use the
telnet command to the IP address you specified in Step 3 of the preceding
procedure.
180 Sun Fire V440 Server Diagnostics and Troubleshooting Guide • July 2003