Advertisement
INTELLI-TRACK™ SPS SYSTEM
NOTE: Before installing the Track section(s) immediately before and after the Roller Access Splice you will need to
remove the Roller Access Splice, if previously installed, to allow room to engage the Drive-In Alignment Strips.
Install Roller Access Splice
NOTE: If you have not previously installed the Roller Access Splice, do so now. The Roller Access Splice is pre-drilled
and ready to receive two fasteners.
1. Align the Roller Access Splice with the end of the Parking Area Assembly and/or Track section(s). Fasten into place.
Use 3/8" Hex Head type fasteners made from one of the following materials: A307 Galvanized or A316 Stainless Steel.
NOTE: ALWAYS USE LOCK WASHERS.
2. Ensure a slight clearance for later removal of the Roller Access Splice.
C.R. Laurence Co., Inc. • 2503 E. Vernon Ave., Los Angeles, CA 90058
THIS FIRST PHASE OF THE INSTALLATION IS COMPLETE
• 1.800.421.6144
P. 7
• crlaurence.com
Advertisement
Need help?
Do you have a question about the INTELLI-TRACK and is the answer not in the manual?
Questions and answers