Table of Contents
Advertisement
● Needle-nose pliers
You need the following tools to assemble the cables for a DC power supply unit:
● AMP 90871-1 hand-crimping tool or equivalent
● Tyco Electronics 58433-3 or equivalent
● Wire-stripper pliers to remove insulation from size 10 AWG solid or stranded, insulated copper wire
NOTE:
Use alpha wire part number 3080 or equivalent (65/30 stranding).
Optional front bezel
Removing the front bezel
Prerequisites
1. Follow the safety guidelines listed in the
2. Keep the bezel key handy.
NOTE:
The bezel key is part of the LED bezel package.
Steps
1. Pressing the bezel at its edges, remove the bezel.
2. Remove the left and right hook holder from the ears.
Figure 33. Removing the front bezel for Rear Accessed configuration
Safety
instructions.
Installing and removing system components
75
Advertisement
Table of Contents
