System Health And System Id Indicator Codes; Idrac Quick Sync 2 Indicator Codes - Dell KGR3H Installation And Service Manual

System health and system ID indicator codes

The system health and system ID indicator is located on the left control panel of the system.
Figure 134. System health and system ID indicator
Table 40. System health and system ID indicator codes
System health and system ID
indicator code
Solid blue
Blinking blue
Solid amber
Blinking amber

iDRAC Quick Sync 2 indicator codes

iDRAC Quick Sync 2 module (optional) is located on the left control panel of the system.
134 System diagnostics and indicator codes
Condition
Indicates that the system is powered on, is healthy, and system ID mode is not active.
Press the system health and system ID button to switch to system ID mode.
Indicates that the system ID mode is active. Press the system health and system ID
button to switch to system health mode.
Indicates that the system is in fail-safe mode. If the problem persists, see the
help section.
Indicates that the system is experiencing a fault. Check the System Event Log
for specific error messages. For information about the event and error messages
generated by the system firmware and agents that monitor system components, go
to qrl.dell.com > Look Up > Error Code, type the error code, and then click Look it
up.
Getting