Table of Contents
Advertisement
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Removing the processor
Prerequisites
WARNING:
The processor will be hot to touch for some time after the system has been powered down. Allow the
processor to cool before removing it.
CAUTION:
The processor is held in its socket under strong pressure. If the release lever is not held firmly, it can
spring up suddenly.
NOTE:
Remove the processor only if you are replacing the processor or the system board. This step is not required when
replacing a heat sink module.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
4.
Remove the heat sink
CAUTION:
An expected CMOS battery loss or CMOS checksum error message may be displayed during the first
instance of powering on the system after replacing the processor or system board. To resolve this issue, go to
setup option to configure the system settings.
Steps
1. Release the socket lever by pushing the lever down and out from under the tab on the processor shield.
2. Lift the lever upward until the processor shield lifts.
CAUTION:
The processor socket pins are fragile and can be permanently damaged. Be careful not to bend the
pins in the processor socket when removing the processor out of the socket.
3. Lift the processor out of the socket.
NOTE:
Ensure that the processor and the bracket are placed in the tray after you remove the heat sink.
Figure 43. Removing the processor
Next steps
Replace the processor
.
After working inside your
Safety
Before working inside your
.
system.
instructions.
system.
Installing and removing system components
53
Advertisement
Table of Contents
