Table of Contents
Advertisement
Table 5-1
Fatal error messages
Error Message
Task
Explanation
Error Recovery Procedure
"Link reader is dying– Rebirth to Bring up link"
linkread
A system error has occurred.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then call your Northern Telecom service representative.
"Link reader task is not running"
naclink
A system error has occurred.
The task should begin its recovery process. If it does not, shut down the system and restart the
process from the maintenance console. If the problem persists, call your Northern Telecom
service representative.
"Linkreader is not active, restarts"
naclink
A system error has occurred.
The task should begin its recovery process. If it does not, shut down the system and restart the
process from the maintenance console. If the problem persists, call your Northern Telecom
service representative.
"MAX_DEV_TYPES is inconsistent"
mpsa
A system error has occurred.
Re-install the hardware and software if there were errors during the most recent
installation/upgrade of the NAC system. If there were no errors during the installation/upgrade
or the problem persists after re-installation, call your Northern Telecom service representative.
"max number of lines exceeded for rpt template"
sys_rpts
An internal system variable has reached an illegal state.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then call your Northern Telecom service representative.
"Memory allocation failure"
<Task>
No available memory was found. The task should begin its recovery process and will start again
without user intervention. If the problem reoccurs, shut down the system. Verify that the system
is configured with the correct amount of memory. If the problem reoccurs then call your Northern
Telecom service representative.
Network Administration Center System Administration and Maintenance Guide Product release 2
Module
Umprotocol.c
Unaclink.c
Ucom_hdl.c
Udev_info.c
Urpt_tmpl.c
<Module>
NAC error messages 5-31
Advertisement
Table of Contents
