Table of Contents
Advertisement
5-64 NAC error messages
Table 5-2
Warning error messages
Error Message
Task
Explanation
Error Recovery Procedure
"Cannot create name_table: out of memory"
cquery
Either insufficient memory was installed in the system, irregular system activities occurred, or
a software error was detected.
Ignore this message if this is an isolated incident. Otherwise, shut down and restart the system.
If the problem persists, call your Northern Telecom service representative.
"Cannot delete file %s"
cquery
A file was not found.
Ignore this message if this is an isolated incident. Otherwise, shut down and restart the system.
If the problem persists, call your Northern Telecom service representative.
"Cannot determine grafcap for %s"
libcommon
A system error has occurred.
Shut down and restart the system. Repeat the print function. If the problem reoccurs then call
your Northern Telecom service representative.
"Cannot determine node_id for node_addr %d [%d]"
cquery
A database problem occurred.
Verify that the NAC installation had no errors. If so, then call your Northern Telecom service
representative. Otherwise, reinstall the NAC software. Call your Northern Telecom service
representative if the problem persists.
"Cannot empty pipe %s"
cquery
A system error has occurred.
Ignore this message if this is an isolated incident. Otherwise, shut down and restart the system.
If the problem persists, call your Northern Telecom service representative.
"Cannot extract data from node_addr %d"
cquery
Report fails to extract data from a MAX node.
Verify the Network Link hardware and the Link's status. Check the error messages at the MAX
node to determine the cause of the failure.
"Cannot find name index"
cquery
An internal system variable has reached an illegal state.
If the problem reoccurs, then shut down and restart the system.
553-4011-510 Standard 1.0 November 1994
Module
Ucquery.c
Ucquery.c
Uprint_job.c
Ucquery.c
Ucquery.c
Ucquery.c
Ucquery.c
Advertisement
Table of Contents
