Table of Contents
Advertisement
5-144 NAC error messages
Table 5-2
Warning error messages
Error Message
Task
Explanation
Error Recovery Procedure
"The node ID [%d] is invalid"
ft_server
A database error has occurred.
Verify that the NAC installation has no errors. If so, then call your Northern Telecom service
representative. Otherwise, reinstall the NAC software. Call your Northern Telecom service
representative if the problem persists.
"The node ID [%d] is invalid"
ft_server
A database error has occurred.
Verify that the NAC installation has no errors. If so, then call your Northern Telecom service
representative. Otherwise, reinstall the NAC software. Call your Northern Telecom service
representative if the problem persists.
"There were only %d nodes active instead of %d"
cquery
A system error has occurred.
Shut down and restart the system. If the problem persists, call your Northern Telecom service
representative.
"Too few args. Use: [options] –[<nam> [<src>...] <dst>"
ft_server
A system error has occurred.
Repeat the operation. If the problem reoccurs, then shut down and restart the system. Repeat
the operation again. If the problem persists, call your Northern Telecom service representative.
"Too few args. Use: [options] –[<nam> [<src>...] <dst>"
ft_server
A system error has occurred.
Repeat the operation. If the problem reoccurs, then shut down and restart the system. Repeat
the operation again. If the problem persists, call your Northern Telecom service representative.
"Too many (%d) retransmissions. Dest. seems down/slow"
ft_server
Indicates there have been many retransmissions to the destination node.
The task should begin its recovery process and start again without user intervention. If the
problem persists, check your hardware connection. If this does not correct the problem, call your
Northern Telecom service representative.
553-4011-510 Standard 1.0 November 1994
Module
ft_server.c
fxfr.c
Ucquery.c
ft_server.c
fxfr.c
fxfr.c
Advertisement
Table of Contents
