Informational Error Messages - Northern Telecom NAC User Manual

Table 5-3

Informational error messages

Error Message
Task
Explanation
Error Recovery Procedure
"NCC is not in product mode"
display
Indicates the system is not in product mode.
Informative; no user intervention is necessary.
"No sanity form linkreader"
naclink
Linkreader does not report to the system.
The task should restart the process by itself. If the problem still persists, call your Northern
Telecom service representative.
"Node_addr %d is restarting current state %d"
cquery
Informative.
No user intervention is required.
"Node_id %d in unit %s is no longer valid"
cquery
Informative.
No user intervention is required.
"Node %d MAX node has been rebooted"
naclink
Indicates the specified MAX node has been rebooted.
Informative; no user intervention required.
"Node %d Network connection to MAX is down"
naclink
Indicates the specified MAX node has been down.
Informative; no user intervention is required.
"Node %d Network connection to MAX is up"
naclink
Indicates the specified MAX node is up.
Informative; no user intervention is needed.
"Not initialized s64"
linkread
Modem register (s64) will not be initialized.
Informative; no user intervention is necessary.
"Opened the named pipe [%s] with descriptor %d"
ft_server
Indicates the pipe is opened with the specified descriptor.
Informative; no user intervention is necessary.
Network Administration Center System Administration and Maintenance Guide Product release 2
Module
Uncc_main.c
Unaclink.c
Ucquery.c
Ucquery.c
Ucmis_sub.c
Ucmis_sub.c
Ucmis_sub.c
Usetty.c
ft_server.c
NAC error messages 5-167