Northern Telecom NAC User Manual page 191

Table 5-2
Warning error messages
Error Message
Task
Explanation
Error Recovery Procedure
"system error:Would deadlock"
liberror
Informative only.
Another error message will follow that will indicate the task that is generating the error. If the
description of the error message that follows instructs you to call your Northern Telecom service
representative, report this system error message together with the error message that follows.
"Table form has already been created"
lib_usrif
An internal variable has reached an illegal state.
Ignore this message if this is an isolated incident.
"Table form has not yet been created"
lib_usrif
An internal variable has reached an illegal state.
Ignore this message if this is an isolated incident.
"table full, cannot add entry"
nccrcv
The system limit has been reached.
Refer to the product specs to check configuration.
"Terminal Device not found in sERDEVS"
display
A database error has occurred.
Check your release materials (that is, version number and system type). If they appear to be
correct, reinstall the NAC release. If the problem still persists, call your Northern Telecom
service representative.
"Terminal %s not attached or not receiving"
display
A system error has occurred.
Shut down the system. Run the diagnostics "Run I/O test" to ensure the terminals are
connected. Restart the system. If the problem still persists, call your Northern Telecom service
representative.
"The FT request command is longer than maximum (%d)"
ft_server
A system error has occurred.
Repeat the operation. If the problem reoccurs, then shut down and restart the system. Repeat
the operation again. If the problem persists, call your Northern Telecom service representative.
Network Administration Center System Administration and Maintenance Guide Product release 2
Module
ACD_err.c
table.c
table.c
Utcup.c
Uterm_setup.c
Udisplay.c
ft_server.c
NAC error messages 5-141