Table of Contents
Advertisement
Parameter
Max. input data resolution
Bit depth
EDID
HDCP
3.1.2.3 Specifications HDMI 2.0
Specifications
Regarding HDMI 2.0: The decryption protocol HDCP 2.2 are enabled and valid in this unit.
Parameter
Connector
Signal characteristics
Max. cable length
Max. pixel rate
Max. input data resolution
Bit depth
EDID
HDCP
Ethernet
Audio return
HDCP
3.1.2.4 Specifications HDBase T input
The HDBaseT standard allows the link to also be used as a regular network port. In addition to
carrying video data, it can also be connected to regular ethernet network without carry out any video
data.
Due to limitations in the projector and network standards, only the LAN and the HDBaseT should be
used for network traffic, but not both simultaneously. If both are connected simultaneously it might
lead to undefined behavior where traffic is not being sent on the link indicated by the IPaddress.
This is only valid when the projector has a firmware version 2.1 or higher installed.
Specifications
Parameter
Reference specification
Connector
Signal characteristics
Max. cable length (1080p/48b/60Hz)
Getting the projector started
Value
2560x1600@120Hz WQXGA / 3840x2400 @60Hz
(4K ) Max
8, 10, 12 bit
Supported
Supported
Value
Standard HDMI
Digital, TMDS
2 m (24 AWG)
594 MHz
3840x2160 @60Hz
8, 10, 12 bits
Supported
Supported
No
No
Supported
Value
HDBaseT 1.0 Specification, June 2010
Standard RJ-45, 8P8C
HDBaseT
100 m (Cat5e/6), Pixel Clock <=225HHz, Video
Datarate <=5.3Gbps
70 m (Cat5e/6), Pixel Clock >225HHz, Video
Datarate >5.3Gbps
R5911698 /07
Bragi
33
Advertisement
Table of Contents
