Can't Print Crop Continue; Service Call; Sheet Too Small Continue; Sheet Set Error Set Again - Roland VersaUV LEC2-300 User Manual

CAN'T PRINT CROP CONTINUE?

The size of the data including the crop marks is larger than the printing area of the loaded media.
To continue performing output without correcting this, press [ENTER]. At this time, the crop marks and the portion
extending beyond the printing area are not output. To stop output, stop sending data from the computer, and then
raise the loading lever. Make the printing area wider, for example, by replacing the media with a larger piece of
media, and then send the data again.
The size of the data being output is too small.
Make the horizontal-direction (scan-direction) size of the data at least 65 mm (2.6 in.). To continue performing
output without correcting this, press [ENTER]. At this time, the data is output without printing the crop marks. To
stop output, stop sending data from the computer, and then raise the loading lever. Change the size of the data,
and then send the data again.

SERVICE CALL ****

An unrecoverable error occurred or part replacement that must be performed by a service technician is re-
quired.
Note the number displayed, and then switch off the sub power. After you switch off the power, inform your au-
thorized Roland DG Corporation dealer of the number that appeared on the display.

SHEET TOO SMALL CONTINUE?

The size of the data is larger than the printing area of the loaded media
To continue performing output without correcting this, press [ENTER]. At this time, the portion extending beyond
the printing area is not output. To stop output, stop sending data from the computer, and then raise the loading
lever. Make the printing area wider, for example, by replacing the media with a larger piece of media, and then
send the data again.

SHEET SET ERROR SET AGAIN

[EDGE DETECTION] is set to "ENABLE", but transparent media was loaded.
Raise the loading lever, set the [EDGE DETECTION] menu item to DISABLE, and then reload the media. Lower the
loading lever, and then press the [ENTER] key.
RELATED LINKS
・ P. 27 "Setup of Roll Media"
・ P. 38 "Setup of Sheet Media"
・ P. 127 "Using Transparent Media"
TEMPERATURE IS TOO LOW **°C
The temperature of the location where the machine is installed has fallen below the ambient temperature at
which the machine can operate.
Operation cannot be continued. Turn off the sub power. The displayed temperature is the current ambient temper-
ature of the installation location. Bring the installed location to a temperature at which operation is possible (20 to
32°C [68 to 90°F]), allow the machine to come to room temperature, and then turn on the power.

DATA ERROR CANCELING...

Output was stopped because a problem was found in the received data.
Operation cannot be continued. Completing the data cancellation will clear the message. Check for a problem with
the connector cable or the computer, or if the printer data has any defects (a color is designated that cannot be
output, etc.). Once the problem or defect has been corrected, send the data again.
Error Messages
5. Messages on the Operation Panel
273