Ge1 Or Ge2 Cable Connection Through The Service Panel Base - Extreme Networks ExtremeWireless AP560i Installation Manual

GE1 or GE2 Cable Connection Through
the Service Panel Base
GE1 or GE2 Cable Connection Through the Metal Sloping Bracket
Learn how to connect the GE1 or GE2 cable using the front or the rear holes on the sides of the service
panel base or the large conduit hole on the metal sloping bracket.
About This Task
The GE1 or GE2 cable is connected through the front or the rear holes on the sides of the service panel
base.
The following hardware is required to attach the GE1 or GE2 cable through the service panel base hole:
•
GE1 or GE2 cable
•
One blank conduit cover to cover the front hole on the side of the service panel base
•
One 1 in. or ¾ in. conduit cover, depending on the circumference of the GE1 or GE2 cable
•
One or two blank conduit covers for the metal sloping bracket
•
Service panel base
•
Service panel top
Figure 14: Service panel metal conduit covers
Callout
A
B
C
Description
Blank conduit cover to cover the front hole on the side of the service panel
base
½ in. conduit cover
¾ in. conduit cover
ExtremeWireless™ AP560i Access Point
on page 40
39