Connect Antennas - Extreme Networks ExtremeWireless AP3000X Installation Manual

Access Point Installation
6. Tighten the beam clip top screw to a torque of 50 in-lbs.
Figure 15: Beam clip top screw
Call out
1

Connect Antennas

Before You Begin
Locate the 2 RPSMA dual banded 2.4/5 GHz antennas which are shipped with the
access point.
About This Task
Connect the included antennas and adjust the antennas for maximum signal.
Procedure
1. Thread the antennas onto the RP-SMA connector.
2. Torque the antennas to 5 in-pounds.
3. Twist all antennas so the bend opening is towards the radome.
Adjust the two 2.4/5 GHz antennas and the two permanently attached antennas.
Description
Beam clip top screw that is used to attach the beam
accessory bracket to a beam
ExtremeWireless™ AP3000X Access Point Installation Guide
Connect Antennas
33