Ip Parameters (Default Profile) Screen - Netopia R6100 Reference Manual

If Must Match a Defined Profile is set to No, then an IPX Enabled item is visible. Toggling this item to Yes
or No (the default) controls whether or not IPX will be supported on the ADSL link. If IPX Enabled is set to
Yes, an IPX Parameters item becomes visible. If you select IPX Parameters, the IPX Parameters screen
appears (see "IPX parameters (default profile) screen" on page
various IPX parameters for ADSL connections established without an explicitly configured connection
profile.
IP Parameters (Default Profile) screen
If you are using RFC1483 datalink encapsulation, the IP Parameters (Default Profile) screen allows you to
configure various IP parameters for ADSL connections established without an explicitly configured connection
profile:
Address Translation Enabled:
Filter Set (Firewall)...
Remove Filter Set
Receive RIP:
Transmit RIP:
Return/Enter accepts * Tab toggles * ESC cancels.
For an ADSL link, Network Address Translation (NAT) is disabled by default in the Default Profile. You can enable
it by toggling Address Translation Enabled to Yes. For details on setting up IP Parameters see
page 10-1.
IP Parameters (Default Profile)
WAN and System Configuration 8-21
8-22). This screen allows you to configure
No
Both
Off
"IP Setup" on