Netopia R6100 Reference Manual page 72

8-14 User's Reference Guide
Remote IPX Network:
Path Delay:
NetBios Packet Forwarding:
Incoming Packet Filter Set...
Outgoing Packet Filter Set...
Incoming SAP Filter Set...
Outgoing SAP Filter Set...
Periodic RIP Timer:
Periodic SAP Timer:
Configure IPX requirements for a remote network connection here.
9. Toggle or enter any IPX Parameters you require and return to the Add Connection Profile screen by pressing
Escape. For more information, see
10. Select Interface Group and press Return. From the pop-up menu select either Primary or Backup. If you
select Primary, the profile is applied to your primary WAN interface (the ADSL link). This would be desirable
if you were creating a profile to store your authentication information for a PPP connection over the ADSL
link. If you select Backup, the profile is applied to your backup interface, whether that is an asynchronous
modem attached to the Auxiliary port or a V.90 or ISDN WAN interface module installed in the second WAN
slot in the router. For more information, see
11. Select ADD PROFILE NOW and press Return. Your new Connection Profile will be added.
If you want to view the Connection Profiles in your router, return to the WAN Configuration screen, and
select Display/Change Connection Profile. The list of Connection Profiles is displayed in a scrolling pop-up
screen.
IPX Profile Parameters
"IPX Setup" on page 12-1.
"Dial Backup" on page
00000000
10
Off
<<NONE>>
<<NONE>>
<<NONE>>
<<NONE>>
60
60
9-1.