Table of Contents
Advertisement
Through the console port, using a local terminal (see
page
6-3)
You can also retrieve the Netopia R6000 Series's configuration information and remotely set its parameters
using the Simple Network Management Protocol (see
Open a Telnet connection to the router's IP address; for example, "192.168.1.1."
The console screen will open to the Main Menu, similar to the screen shown below:
Return/Enter goes to Easy Setup -- minimal configuration.
You always start from this main screen.
Navigating through the configuration screens
To help you find your way to particular screens, some sections in this guide begin with a graphical path guide
similar to the following example:
Main
Menu
This particular path guide shows how to get to the Network Protocols Setup screens. The path guide represents
these steps:
1.
Beginning in the Main Menu, select System Configuration and press Return. The System Configuration
screen appears.
2.
Select Network Protocols and press Return. The Network Protocols screen appears.
3.
Select IP Setup and press Return. The IP Setup screen appears.
To go back in this sequence of screens, use the Escape key.
Netopia R6100 v4.8
Easy Setup...
WAN Configuration...
System Configuration...
Utilities & Diagnostics...
Statistics & Logs...
Quick Menus...
Quick View...
System
Configuration
"Connecting a Console Cable to your Router" on
"SNMP" on page
14-12).
Network Protocols
Setup
Console-Based Management 6-5
IP Setup
Advertisement
Table of Contents
