Table of Contents
Advertisement
9-4 User's Reference Guide
If you select (Wan Module 2) Setup... and have a V.90 modem card in slot 2, the following screen appears:
Modem Dialing Prefix:
PBX Dialing Prefix:
Answer on Ring Type...
Speaker On...
Speaker Volume...
Enter Information supplied to you by your telephone company.
You can edit the Modem Dialing Prefix, if necessary, add a PBX Dialing Prefix (such as "9" for an out-
side line), set the conditions for whether the modem will Answer on Ring Type incoming calls, adjust
the conditions for when the Speaker is On, and adjust the Speaker Volume, from the pop-up menus.
The default Modem Dialing Prefix is ATDT. You can edit it if you need to.
You can enter a PBX Dialing Prefix such as "9" if you are on a PBX or Centrex phone system and must
dial a prefix for an outside line.
You may choose to selectively answer inbound calls, based on a distinctive ring pattern, using Answer
on Ring Type... This permits you to set up a party line configuration where a fax machine or other
device shares the line, but uses a different telephone number and ring pattern. Supported options
are:
Ring Type:
Any
Ring A
Ring B
Ring C
Never
You may choose when the Netopia R6000 Series's modem connection tones are audible in the
Internal Modem Setup
(the default) any pattern
2.0 sec ON, 4.0 sec OFF (normal North American ring pattern)
0.8 sec ON, 0.4 sec OFF, 0.8 sec ON, 4.0 sec OFF
0.4 sec ON, 0.2 sec OFF, 0.4 sec ON, 0.2 sec OFF, 0.8 sec ON, 4.0 sec
OFF
the line will not answer to any ring pattern
ATDT
Any
Until Carrier
2-Medium
Description:
Advertisement
Table of Contents
