Delayed remote configuration change toggle
The Netopia R6000 Series supports delaying some configuration changes until after the router is restarted.
If your router is preconfigured by your service provider, or if you are not remotely configuring the router, you can
leave this setting unchanged.
The purpose of this feature is to defer configuration changes only when remotely configuring or reconfiguring the
router to prevent premature console disconnection. When this feature is enabled, no changes to the WAN
setup, datalink encapsulation, Connection Profiles, DLCIs, or Default Gateways will take effect until after the
router is restarted. Until the router is restarted the WAN link and the routing table remain unaffected.
A single setting in the Choose Interface to Configure screen controls this feature, as shown below.
Choose Interface to Configure
CMN SDSL (Wan Module 1) Setup...
Auxiliary Serial Port Setup...
Configuration Changes Reset WAN Connection:
WAN and System Configuration 8-9
Yes