Table of Contents
Advertisement
Receive RIP:
Transmit RIP:
TX RIP Policy...
Routing Information Protocol (RIP) is needed if there are IP routers on other segments of your Ethernet
network that the Netopia R6000 Series needs to recognize. If this is the case select Receive RIP and
select v1, v2, or Both from the pop-up menu. With Receive RIP set to v1, the Netopia R6000 Series's
Ethernet port will accept routing information provided by RIP packets from other routers that use the same
subnet mask. Set to v2, the Netopia R6000 Series will accept routing information provided by RIP packets
from other routers that use different subnet masks. Set to Both, the Netopia R6000 Series will accept
information from either RIP v1 or v2 routers.
If you want the Netopia R6000 Series to advertise its routing table to other routers via RIP, select Transmit
RIP and select v1, v2 (broadcast), or v2 (multicast) from the pop-up menu. With Transmit RIP v1 selected,
the Netopia R6000 Series will generate RIP packets only to other RIP v1 routers. With Transmit RIP v2
(broadcast) selected, the Netopia R6000 Series will generate RIP packets to all other hosts on the
network. With Transmit RIP v2 (multicast) selected, the Netopia R6000 Series will generate RIP packets
only to other routers capable of recognizing RIP v2 packets.
RIP Profile Parameters
Both
v2 (multicast)
Poison Reverse
WAN and System Configuration 8-17
Advertisement
Table of Contents
