Leds Start-Up Sequence - Netopia R6100 Reference Manual

3-6 User's Reference Guide

LEDs start-up sequence

The WAN 1 Management status light (LED #2 in the figure above) displays the status of the Netopia R6000
Series' attempt to connect to the DSLAM.
When the router is powered on:
Initially the WAN 1 Management LED and the WAN1 Channel 1 LED (LED #4 in the figure above) are dark.
The WAN 1 Ready LED (LED #3 in the figure above) begins to blink red as the router attempts to establish
communication with the WAN interface.
The WAN 1 Ready LED goes solid green once it establishes communication with the WAN interface.
The WAN 1 Management LED will then be either solid yellow (no signal from DSLAM) or flashing yellow;
then be dark between training attempts for a total cycle time of 3 seconds; then repeat as it trains.
Once trained, the WAN 1 Management LED goes dark, and the WAN 1 Channel 1 LED will be solid green.
It will flash yellow for traffic.