Table of Contents
Advertisement
IP Parameters (Default Profile) screen
If you are using RFC1483 datalink encapsulation, the IP Parameters (Default Profile) screen allows you to
configure various IP parameters for DSL connections established without an explicitly configured connection
profile:
Address Translation Enabled:
Filter Set (Firewall)...
Remove Filter Set
Receive RIP:
Transmit RIP:
Return/Enter accepts * Tab toggles * ESC cancels.
For most DSL links, Network Address Translation (NAT) is disabled by default in the Default Profile. You can
enable it by toggling to Yes.
For details on setting up Filter Sets see
For details on setting up RIP Parameters see
The ATMP/PPTP Default Profile
The ATMP/PPTP Default Profile screen controls whether or not your device will answer VPN connection attempts
without an explicitly configured connection profile. See
information.
Scheduled Connections
Scheduled connections are useful for PPP, PPTP, and ATMP connection profiles.
To go to the Scheduled Connections screen, select Scheduled Connections in the WAN Configuration screen.
IP Parameters (Default Profile)
"About Filters and Filter Sets" on page
"IP Setup" on page
Main
Menu
No
Both
Off
9-1.
"Virtual Private Networks (VPNs)" on page 11-1
WAN
Configuration
WAN and System Configuration 8-15
12-4.
Scheduled
Connections
for more
Advertisement
Table of Contents
