Table of Contents
Advertisement
System Configuration Screens
You can connect to the Netopia 4741's system configuration screens in either of two ways:
By using Telnet with the device's Ethernet port IP address
Through the console port, using a local terminal (see
page
5-3)
You can also retrieve the Netopia 4741's configuration information and remotely set its parameters using the
Simple Network Management Protocol (see
Open a Telnet connection to the device's IP address; for example, "192.168.1.1."
The console screen will open to the Main Menu, similar to the screen shown below:
Return/Enter goes to Easy Setup -- minimal configuration.
You always start from this main screen.
Navigating through the System Configuration screens
To help you find your way to particular screens, some sections in this guide begin with a graphical path guide
similar to the following example:
This particular path guide shows how to get to the IP Setup screens. The path guide represents these steps:
Beginning in the Main Menu, select System Configuration and press Return. The System Configuration
"SNMP" on page
Netopia 4741 v5.1.1
Easy Setup...
WAN Configuration...
System Configuration...
Voice Configuration...
Utilities & Diagnostics...
Statistics & Logs...
Quick Menus...
Quick View...
Main
Menu
"Connecting a Console Cable to Your Device" on
13-13).
System
Configuration
WAN and System Configuration 8-21
IP Setup
Advertisement
Table of Contents
