Table of Contents
Advertisement
The ATMP/PPTP Default Profile
The ATMP/PPTP Default Profile screen controls whether or not your device will answer VPN connection attempts
without an explicitly configured connection profile. See
information.
System Configuration Screens
You can connect to the Netopia 4753's system configuration screens in either of two ways:
By using Telnet with the device's Ethernet port IP address
Through the console port, using a local terminal (see
page
6-3)
You can also retrieve the Netopia 4753's configuration information and remotely set its parameters using the
Simple Network Management Protocol (see
Open a Telnet connection to the device's IP address; for example, "192.168.1.1."
The console screen will open to the Main Menu, similar to the screen shown below:
Return/Enter goes to Easy Setup -- minimal configuration.
You always start from this main screen.
Navigating through the System Configuration screens
To help you find your way to particular screens, some sections in this guide begin with a graphical path guide
similar to the following example:
"Virtual Private Networks (VPNs)" on page 12-1
"SNMP" on page
Netopia 4753 v5.1
Easy Setup...
WAN Configuration...
System Configuration...
Voice Configuration...
Utilities & Diagnostics...
Statistics & Logs...
Quick Menus...
Quick View...
WAN and System Configuration 9-15
"Connecting a Console Cable to Your Device" on
14-13).
for more
Advertisement
Table of Contents
