Installation Procedure - Mellanox Technologies MSX6536-10R Hardware Installation Manual

1. Put an ESD prevention wrist strap on your wrist, and make sure there is good contact between
your body and the strap.
2. Plug the other end of the wrist strap to a valid ground. Make sure that this is a tight fit.

1.6.3 Installation Procedure

Installing the chassis will be a lot easier if you can remove the sides of the rack.
You will need a fork lift, to move and insert the chassis into the rack.
1.6.3.1 Requirements
You will need:
• #2 phillips screwdriver
• a fork lift
• measuring tape
The installation will be much easier with a power screwdriver.
It is recommended to use AWG6 or 4mm diameter wire for grounding purposes.
It is recommended to have at least two people for the duration of the installation proce-
dure. Use a mechanical lift to raise this chassis. If not, use enough manpower to ensure
the safety and wellbeing of all of the people involved in the installation.
1.6.3.2 Installation and Cable Management Kit Parts
• Parts included in the installation kit:
- 1 shelf with brackets pre-installed
- 1 left side upper bracket offset
- 2 lock down bars
- 8 lock washers for the upper brackets to
vertical support
- 12 hex head bolts – 8 for the upper 
brackets and 4 for the shelf extension
12
• #3 phillips screwdriver
• a grounding lug
• ground wire of sufficient length and gauge to properly ground the
chassis
- 1 shelf extension
- 1 right side upper bracket offset
- 2 upper bracket washers
- 12 lock washers for the upper brackets to
upper bracket offsets
- 34 caged nuts 20 for the shelf and 14 for the
chassis faceplate
Installation
Mellanox Technologies