Figure 10: U Numbering Above Shelf - Mellanox Technologies MSX6536-10R Hardware Installation Manual

Step 10. Place 14 caged nuts into the vertical rack support at the locations corresponding to the
holes in the chassis faceplate. The holes in the faceplate start at 2U above the shelf and
are spaced every 4U centered as you go up the vertical rack support. There are 7 holes
on each side.
1.6.3.6 Inserting the Chassis
The chassis is on ball bearings and can roll easily. Be aware that the chassis can roll off
of the pallet. Should the chassis start to fall, move out of the way. The chassis can
cause grave bodily harm should it fall on or near you.
Step 1. Put the container on the fork lift.
20

Figure 10: U Numbering Above Shelf

2
1
3
2
1
Top of
Shelf
The first cage nut on the spine side goes
here. The rest of the caged nuts go every
4 U units up from here.
Installation
Mellanox Technologies