Table of Contents
Advertisement
Installing Your MultiVOIP 200 Software
The following installation procedures do not provide every
screen or option in the process of installing the MultiVOIP 200
software. It is assumed that a technical person with a thorough
knowledge of Windows and the software loading process is
doing the installation. Once you have installed the software,
you will be instructed on how to configure your MultiVOIP 200,
and finally, on how to deploy your MultiVOIP 200. Additional
information on the MultiVOIP 200 software is provided in the
on-line Help.
Note: The phonebook directory configuration process is
different depending on whether or not you have an enabled
H.323 Gatekeeper resident in your network. The section on
"Configuring Your MultiVOIP 200" will explain these differences.
CAUTION: If you are installing a MultiVOIP 200 behind a
Firewall, the Firewall must support H.323. Refer to your
Firewall user documentation to enable H.323 support.
1. Make certain that your MultiVOIP 200 has been properly
cabled and that it is powered on.
2. Insert the MultiVOIP 200 CD into a CD-ROM drive. The
CD is auto-detectable, so it starts automatically. It may
take 10 to 20 seconds for the Multi-Tech Installation CD
screen to appear.
Installing the Software
13
Advertisement
Table of Contents
