Multitech MultiVOIP 200 MVP200 Quick Start Manual page 19

Configuring the MultiVOIP
Configure each channel for the type of interface you are
connecting to. The Interface tab defaults to Channel 1 in
the Select Channel field. To change the channel number,
click the drop-down arrow and the list of channels is
displayed. Highlight the channel you want to configure.
Note: Feature options are enabled or disabled (grayed out)
according to the interface type that you select. The one
option available for all interface types is the Inter Digit
Time option. This option defines the maximum amount of
time that the unit will wait before mapping the dialed digits
to an entry in the Phone Directory Database. If too much
time elapses between digits, and the wrong numbers are
mapped, you will hear a rapid busy signal. If this happens,
it will be necessary to hang up and dial again. The default
setting is 2 seconds.
14. The Interface group defaults to FXS (Loop Start). Select
the interface option that corresponds to the interface type
being connected to the Voice/Fax Channel 1 jack on the
back panel of the MultiVOIP 200.
19