Installing Your Multivoip Software; Phase 1: Configuring Your Master Multivoip - Multitech MVP200 User Manual

MultiVOIP 200 User Guide

Installing Your MultiVOIP Software

The following installation procedures do not provide every screen or option in the process of installing
the MultiVOIP software. It is assumed that a technical person with a thorough knowledge of Windows
and the software loading process is doing the installation. Additional information on the MultiVOIP
software is provided in Chapter 4, MultiVOIP Software, and in the on-line Helps.

Phase 1: Configuring Your Master MultiVOIP

Configuring your Master MultiVOIP involves software loading and configuration.
Software Loading
The software loading procedure does not provide every screen or option in the loading process. It is
assumed that a technical person with a thorough knowledge of Windows and the software loading
process is performing the installation. Additional information on the MultiVOIP software is provided in
the User Guide supplied with your MultiVOIP.
If you are installing a MultiVOIP behind a firewall, you need to add the following UDP ports to your
firewall.
Q.931 Signaling, Ch1 [900]
Status [5000]
Ch1 RTP [5004]Ch1 RTCP [5005]
Ch2 RTP [5006]Ch2 RTCP [5007]
Refer to your firewall user documentation to enter and open these ports.
1 Run Windows on the PC connected to the MultiVOIP.
2 Insert the MultiVOIP diskette labeled Disk 1 into the disk drive on the PC connected to the
MultiVOIP.
3 Win3.1 users - in Program Manager, click File | Run. In the Run dialog box, type a:\setup or
b:\setup (depending on the location of your floppy disk drive) in the Command Line field and
then click OK.
Win95/98/NT users - click Start | Run. In the Run dialog box click the down arrow and
choose a:\setup or b:\setup (depending on the location of your floppy disk drive), then click
OK.
4 The MultiVOIP Setup welcome screen is displayed.
22
Q.931 Signaling, Ch2 [902]