Table of Contents
Advertisement
MultiVOIP Quick Start Guide
FXS (Loop Start): If a station device; e.g., an analog
telephone, fax machine, or KTS (Key Telephone System) is
connected to the Voice/Fax connector on the back of the
unit, FXS (Loop Start) will likely be the correct Interface.
FXS (Ground Start): If the station device uses ground
start, then choose the FXS (Ground Start) option. Refer to
the device's user documentation.
For both FXS Loop Start and FXS Ground Start , the Ring
Count FXS window allows you to set the maximum
number of rings output on the FXS interface before
hanging up and releasing the line to another call. The
default setting is 8 rings.
Note: Zero (0) means no rings - caller hears a busy tone.
FXO: If you are using an analog extension from your PBX,
then choose the FXO option. Check with your in-house
phone personnel to verify the connection type.
If FXO is selected, the Dialing Options Regeneration,
Flash Hook Timer, and Ring Count groups are enabled.
Check with your local in-house phone personnel to verify
whether your local PBX dial signaling is Pulse or tone
(DTMF). Then, set the Regeneration option accordingly.
The Flash Hook Timer allows you to enter the time, in
milliseconds, for the duration of the flash hook signals
output on the FXO interface. The default setting is 600
milliseconds. The Ring Count FXO window allows you to
set the number of rings received on the FXO interface
before the MultiVOIP 200 answers the incoming call. The
default setting is 2 rings.
Note: Zero (0) means that the MultiVOIP 200 never
answers.
20
Advertisement
Table of Contents
