Table of Contents
Advertisement
MultiVOIP Quick Start Guide
Consecutive Packets Lost defines the number of
consecutive packets that are lost after which the call is
automatically disconnected. The default setting is 30.
Call Duration defines the maximum length of time (in
seconds) that a call remains connected before the call is
automatically disconnected. The default setting is 180
seconds. A call limit of three minutes may be too short for
most configurations. Therefore, you may want to increase
this default value.
23. You can set billing options for inbound and/or outbound
calls by checking them in the Billing Options group and
then entering the charge in cents per number of seconds.
24. A minimum and maximum set of values can be set for
Dynamic Jitter Buffer. When receiving voice packets from
a remote MultiVOIP 200, it is possible to experience
varying delays between packets due to traffic conditions
on the network. This is called Jitter. To compensate for this
effect, the MultiVOIP 200 uses a Dynamic Jitter Buffer. The
Jitter Buffer allows the MultiVOIP 200 to wait for delayed
voice packets by automatically adjusting the length of the
Jitter Buffer between configurable minimum and maximum
values. An Optimization Factor adjustment controls how
quickly the length of the Jitter Buffer is increased when
jitter increases on the network. The length of the jitter
buffer directly effects the voice delay between MultiVOIP
200 gateways.
The Minimum Jitter Value default setting is 150
milliseconds, the Maximum Jitter Value default setting is
300 milliseconds, and the Optimization Factor default
setting is 7.
Note: After configuring a given channel (1 or 2), you can
copy that channel's configuration to the other channel by
clicking the Copy button. Everything on the Billing/Misc
tab will be copied to the other channel.
26
Advertisement
Table of Contents
