Manual Upgrade Procedure - Multitech MultiVOIP 100 MVP110 User Manual

Voice/fax over ip networks h.323 mode

Hide thumbs Also See for MultiVOIP 100 MVP110:

Table of Contents

Manual Upgrade Procedure

Follow this procedure only if you want to manually upgrade your MultiVOIP.

Note: Steps 4-8 must be performed locally via the command port.

1. Run MultiVOIP configuration from your old version of MultiVOIP software and take note of the

current settings. Your MultiVOIP will be reset to factory defaults during this upgrade.

2. Uninstall your old version of MultiVOIP software by selecting the "Uninstall MultiVOIP

Configuration" option from the program group.

3. Install the H.323 compatible software from the MultiVOIP CD.

4. From the program group of the MultiVOIP software, run "Download H.323 Stack" and select the

default file.

5. From the program group of the MultiVOIP software, run "Download Voice Coders" and select the

default file.

6. From the program group of the MultiVOIP software, run "Download Factory Defaults".

7. From the program group of the MultiVOIP software, run "Download Firmware". Enter "*.upg" in

the File Name box and press ENTER.

8. From the program group of the MultiVOIP software, run "Download Firmware" and select the file

named mtvoip.bin.

9. Select MultiVOIP Configuration from the program group and reconfigure your MultiVOIP. The

upgrade is complete.

Chapter 4 - MultiVOIP Software

Table of Contents

Do you have a question about the MultiVOIP 100 MVP110 and is the answer not in the manual?