Upgrade Procedures; Upgrade Software - Multitech MultiVOIP 100 MVP110 User Manual

Voice/fax over ip networks h.323 mode

Hide thumbs Also See for MultiVOIP 100 MVP110:

Table of Contents

Chapter 4 - MultiVOIP Software

Upgrade Procedures

Whenever you upgrade your version of the MVP110 software, you must first install the new software

on your PC. Then use the Upgrade Software function, or download the Firmware, the Factory

Defaults, the Voice Coders, and the H.323 stack to upgrade the MVP110 itself.

Before starting the upgrade process, view the current configuration and write down important data

such as your IP address, and voice channel configurations; these settings must be put back in place

after the software has been upgraded. Multi-Tech also recommends that you use the Print button on

the Phone Directory Database dialog box to have a copy of the phone directory contents.

Four utility programs included in the MVP110 software are to be used only after the unit has been

repaired or upgraded. They are Upgrade Software, Download Firmware, Download Voice Coders,

and Download H.323 Stack.

Note: The software upgrade can only be done from the command port. It can not be done via a

network connection.

If you have obtained a new firmware version, Boot Code, Coders file, or H.323 stack from the Multi-

Tech Web site or another source, do the following:

Click Programs | MultiVOIP 100 | Upgrade Software.

Click Yes. The download process begins.

Enter your LAN IP address, mask, and gateway address in the IP Protocol Default Setup dialog

box. Click OK when finished.

Table of Contents