Changing Channel Parameters; Interface Tab - Multitech MultiVOIP 100 MVP110 User Manual

Chapter 4 - MultiVOIP Software

Changing Channel Parameters

The channel parameters include the interface type and its options, voice and fax settings, billing and
security, and voice communications for the country and region in which the MVP110 is operating. The
Channel Setup dialog box, accessed by clicking Voice Channels on the Setup menu, has four tabs
that display the following categories of channel information -- Interface, Voice/Fax, Billing/Misc, and
Regional.

Interface tab

The Inter Digit Time (in seconds) option in the Dialing Options group defines the amount of time the
MVP110 waits between digits as they are entered by the user. If this timer expires, the MVP110 will
immediately attempt to match the digits entered to an entry in the Phone Directory Database. The
range for this option is 2 to 100 with a default of 2.
FXS Interface
The FXS Interface is used to connect telephones, fax machines, key telephone systems, etc., to the
MVP110. In addition, you need to select either Loop Start or Ground Start. Most of the equipment
mentioned will use Loop Start which is the default.
Ring Count
Enter the maximum number of rings output on the FXS interface (default is 8) before hanging up and
releasing the line to another call.
A setting of 0 (zero) on the FXS interface disables the generation of rings. The caller will receive a
"Busy" tone.
Message Waiting Light
The Message Waiting Light check box must be selected on the originating and answering voice
channel. This enables the number dialed to connect you to the appropriate voice channel, then
output that number on the voice channel. This feature does not work FXS to FXS.
43