Deploying The Voip Network; Remote Site Administrator - Multitech MultiVOIP 100 MVP110 User Manual

Deploying the VOIP Network

For a Proprietary Phone Directory database, the VOIP administrator can deploy the pre-configured slave
MVP110s to their remote sites. The remote site administrators need only connect power to the pre-configured
MVP110, connect the MVP110 to their Ethernet LAN and predefined telephone equipment, and then wait for the
phone directory database to be downloaded.
With the Gatekeeper option enabled on the Phone Directory Database dialog box, all MVP110s are configured
as "Master" and cannot be downloaded. In this case, each MVP110 Phone Book will be programmed with phone
numbers for its own channels. These phone numbers are registered with the H.323 Gatekeeper. See the
"Registering with a Gatekeeper Phone Directory" section discussed earlier.

Remote Site Administrator

The following steps are for MVP110 H.323 endpoints. For non-MVP110 H.323 endpoints, refer to the
appropriate installation documentation.
1. Unpack your MVP110.
2. Connect one end of the power supply to a live AC outlet and connect the other end to the Power
connection on your MVP110 (See Figure 5).
3. Connect a network cable to the ETHERNET (RJ-45) connector on the back of your MVP110.
4. If you are connecting a station device such as an analog telephone, a fax machine, or a Key
Telephone System (KTS) to your MVP110, connect one end of an RJ-11 cable to the Phone
connector on the back of the MVP110 and the other end to the station device.
5. Turn on power to the MVP110 by placing the ON/OFF switch on the right side panel in the ON
position. Wait for the BOOT LED on the MVP110 to go off before proceeding. This may take a
couple of minutes.
6. At this time your VOIP network should be fully operational. Dial one of the sites in your network.
Chapter 3 - Software Loading and Configuration
Figure 5. Remote Site Cable Connection
39