Multitech MultiVOIP 100 MVP110 User Manual page 38

Make certain the Proprietary Phonebook option is enabled and in the Database Type group,
click the Slave option. The Master IP Address field becomes active.
Note: After you have enabled the Slave option, the Slave Status button is replaced by the
Update button. Once your Phone Directory database has been established, you can click this
button to refresh the entries in the Phone Directory Database window.
18. Enter the IP address (204.022.122.118) of the New York Office MVP110 in the Master IP
Address box and enable the Send Status Report to Master so that status reports are sent to
the Master MVP110.
Note: In a Dial-On-Demand (DOD) network, you should leave Send Status Report to Master
disabled. This allows the router to disconnect whenever there is no voice activity. Note that
Slaves with Send Status Report to Master disabled will show up as "Unknown" when viewing
Slave status on the Master.
19. Click OK to return to the Main menu.
20. Click Download Setup to write the new configuration to the slave unit. The Save Setup dialog
box displays.
21. Select the Save Current Setup as User Default Configuration check box and click OK. The
Writing Setup dialog box displays as the setup configuration is written to the MVP110.
22. Check that the Boot LED on the MVP110 is off after the download is complete. This may take
several minutes as the MVP110 reboots.
23. You are returned to the Main menu.
Your MVP110 is operational at this time.
Repeat the process for each of the slave units. When all slaves have been configured, go to
"Deploying the VOIP Network".
Chapter 3 - Software Loading and Configuration
38