Cabling Your Mvp110; Cabling Procedure - Multitech MultiVOIP 100 MVP110 User Manual

Cabling Your MVP110

Cabling your MVP110 involves making the proper Power, Command Port, and Internet connections.
Figure 2-2 shows the back panel connectors and the associated cable connections. The Cabling
Procedure section provides step-by-step instructions for cabling your MVP110.

Cabling Procedure

1. Using the supplied cable, connect the power supply to a live AC outlet, then plug the power
supply into the MVP110 as shown above.
2. Connect the MVP110 to a PC using the RJ-45 to DB9 (female) cable provided with your unit.
Plug the RJ-45 end of the cable into the Command port of the MVP110 and connect the other
end to the PC's serial port.
3. Connect a network cable to the Ethernet 10Base-T connector on the back of the MVP110.
Connect the other end of the cable to your network.
4. If you are connecting a station device such as an analog telephone, a fax machine, or a Key
Telephone System (KTS) to your MVP110, connect one end of an RJ-11 cable to the Phone
connector on the back of the MVP110 and the other end to the station device.
5. Turn on power to the MVP110 by setting the power switch on the right-side panel to the On
position. Wait for the Boot LED on the MVP110 to go off before proceeding. This may take a
couple of minutes.
Note: Since the MVP110 doesn't have a power LED, no LEDs will be on after booting unless the
Ethernet link is active.
Figure 2-2. Cable Connections
Chapter 2 - Installation
19