Installing The Power Supply Unit - Kodak CR 360 Service Manual

Installing the Power Supply Unit

[1] Slide the new power supply into the power supply housing bracket.
[2] Turn over the power supply and install the four 2.5 mm Allen screws (cone).
CB057003
Number-1
and the
Ground cable
CB057003
Number-3
CB057058
Number-2
[3] Install the 7 cables, while ensuring that no washers or screws have been lost in the system.
Caution
Be careful not to damage the fan grill when sliding the new power supply into its housing.
[4] Gently install the power supply into the scanner.
6H4869
Service Procedures
CB057003
Number-2
CB057003
Number-4
CB057058
Number-1
Fan grill
75