Replacing The W0 Sensor; Tools Required; Removing The W0 Sensor - Kodak CR 360 Service Manual

Service Guide
[4] Turn the tray on its underside and push the gray handle into its position until you hear a click.
[5] Perform the cassette release mechanism adjustment procedure. (See

Replacing the W0 Sensor

Tools Required

• 2.5 x 100 mm cable ties
• 2.5 mm Allen wrench
• Wire cutters

Removing the W0 Sensor

Laser Warning
When a service operation is taking place with the cover removed, disconnect the laser according to the procedure in
Activating the Scanner Without the Cover (Laser Deactivated) on Page
service procedure, wear protective safety glasses at all times.
[1] Remove the roof assembly. (See
[2] Remove the tray assembly. (See
[3] Remove the W0 sensor (J511).
98
Replacing the Roof Assembly and Tray Assembly on Page
Replacing the Roof Assembly and Tray Assembly on Page
Adjustment Procedure on Page
26. If the laser must be activated during the
J511
120).
83.)
83.)
6H4869